INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: low volume after enabling convolution, cannot achieve preferred volume levels  (Read 1468 times)

dutchtexan

  • Member
  • *
  • Posts: 2
low volume after enabling convolution, cannot achieve preferred volume levels
« on: October 28, 2018, 07:11:47 pm »
Hello,

I used DRC to establish convolution filers in JRiver 23. I had to enable volume leveling to prevent severe clipping of the signal. I use an HDMI connection from my CAPS3 to Marantz 8802A. Before enabling Convolution I was listening at average volume level -24. since convolution I have to use around volume level -12 to reach similar levels. However, with pre-loudness war music I find that I have to go much higher in volume but I cannot go beyond 0 on the Marantz. If I would enable volume leveling the problem would only be worse. I have system volume disabled. But any of the volume settings give me the same problem. Is there a way to create more headroom without disabling convolution? I have a feeling there has to be a way but I simply cannot figure it out. Hope to hear from fellow users soon.

All the best.
Logged

mattkhan

  • MC Beta Team
  • Citizen of the Universe
  • *****
  • Posts: 4226
Re: low volume after enabling convolution, cannot achieve preferred volume levels
« Reply #1 on: October 29, 2018, 05:32:40 am »
this suggests your filter is cutting heavily overall, is it? i.e. what is the frequency response of your filter?
Logged

dutchtexan

  • Member
  • *
  • Posts: 2
Re: low volume after enabling convolution, cannot achieve preferred volume levels
« Reply #2 on: October 29, 2018, 08:46:12 pm »
Hello,

I do not know how to measure the frequency response of the filter. I have installed REW and I own XZT measuring kit. How do i go about measuring the response of the filter?
Logged

JimH

  • Administrator
  • Citizen of the Universe
  • *****
  • Posts: 72438
  • Where did I put my teeth?
Re: low volume after enabling convolution, cannot achieve preferred volume levels
« Reply #3 on: October 30, 2018, 12:42:39 am »
Our wiki has a topic on convolution, but that's probably a REW question.
Logged

mattkhan

  • MC Beta Team
  • Citizen of the Universe
  • *****
  • Posts: 4226
Re: low volume after enabling convolution, cannot achieve preferred volume levels
« Reply #4 on: October 30, 2018, 01:54:40 am »
Quote from: dutchtexan on October 29, 2018, 08:46:12 pm
Hello,

I do not know how to measure the frequency response of the filter. I have installed REW and I own XZT measuring kit. How do i go about measuring the response of the filter?
The software you use to create the filter would usually show you the frequency response of that filter. What are you using?
Logged
Pages: [1]   Go Up
« previous next »