INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: [RME ADI2-pro] ASIO Loopback not working any more  (Read 466 times)

stanzani

  • Galactic Citizen
  • ****
  • Posts: 463
  • Music and Audio enthusiast
[RME ADI2-pro] ASIO Loopback not working any more
« on: September 13, 2018, 03:07:27 am »

Move to a most appropriate section in the forum (cannot delete the message here, sorry)
.
.
.
Hello
this is for RME ADI2 PRO users using the ASIO loopback with JRiver.
back from holiday I update both JRiver 24, ASIO4ALL, RME ADI2PRO USB ADC and DAC) Firmware and Driver

My setup is as following

- a server PC hosting JRiver is connect by USB to the RME ADI2-PRO

- The balanced output of my pre phono is connected to he analogue balanced input of the RME (ADC)

- the RME is in USB mode (get and put adigital audio on the USB)

- RME clock source internal  @96K (sepecified by the driver on the PC

JRiver

- DAC: driver audio RME Madiface

- ADC: ASIO4ALL IN, with24@96K sampling frequency

- DSP Studio: resample all formats at 24@96K

The pre phono is working (the RME ADI2 PRO set in preamp mode happily works)

This setup is intended to process the vynil sound with Dirac DRC and declicker by getting the vynil sound at 24@96 from RME A/D, ASIO-loopbacking into JRiver, apply DSP Studio and then sending via USB to the RME DAC.

This was working fine until July 2018 timeframe

Back from holiday, I upadted all (bad idea?) and the File->Open Live->ASIO Loopback (set the ASIO4ALL @96KHz) is not getting audio from the RME ...

Didi anybody expeciended this? Any advice?

Thank so much to anybody who'll help
Logged
Stereo:
DAW: Fanless Case Streatcon 7 with MSI A97I mobo, 2 x 8G RAM (Hynix) with Intel I5 CPU.
NAS: QNAP TS-531 with 5x4TB HDDs
DAC/ADC: RME ADI2 PRO
Speakers (active): 2 x ATC SCM50ASL
Subs (active): 2 x REL 528 Signature
Pages: [1]   Go Up