INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: New NUC Id - fails to boot  (Read 1473 times)

markgough

  • Recent member
  • *
  • Posts: 22
New NUC Id - fails to boot
« on: February 16, 2021, 08:20:36 pm »
I've had this NUC Id for a month or two. It's worked OK until today when several failed attempts at start-up ended with an "A bootable device has not been detected" message.

This is the NUC information: Id 25.0.11  MC 26.0.107-2 Engen 1.0.69, NUC 300 7CJYH

I'd welcome any suggestions! Thanks, Mark
Logged

JimH

  • Administrator
  • Citizen of the Universe
  • *****
  • Posts: 72438
  • Where did I put my teeth?
Re: New NUC Id - fails to boot
« Reply #1 on: February 16, 2021, 08:35:35 pm »
Check the cables to make sure they are tight.  Power off first.
Logged

markgough

  • Recent member
  • *
  • Posts: 22
Re: New NUC Id - fails to boot
« Reply #2 on: February 17, 2021, 03:26:58 pm »
Doh! Loose power cord - fixed. Thank you!
Logged

JimH

  • Administrator
  • Citizen of the Universe
  • *****
  • Posts: 72438
  • Where did I put my teeth?
Re: New NUC Id - fails to boot
« Reply #3 on: February 17, 2021, 04:00:13 pm »
Good you found the cause.
Logged
Pages: [1]   Go Up
« previous next »