Topic: How to set SmartList Properties? (Read 736 times)

bob_j · « **on:** December 15, 2002, 07:47:00 am »

I can't figure out how to set the properties of a smartlist. The interface is not intuitive and the help doesn't help. I can make a new smartlist but can't set the properties. Can someone give me a hint?
Thanks
bj

bob_j · « **Reply #1 on:** December 16, 2002, 01:22:48 am »

Does anyone know how to do this or is this a stupid question?

Phil Lee · « **Reply #2 on:** December 18, 2002, 03:54:20 am »

At the top of the smartlist screen there is an entry field where you can enter smartlist parameters manually or click on the wand button on the left hand side to show a menu listing all the parameters to create your query.

You can see an example here:

http://www.home.earthlink.net/~ashawley01/data/smartlist_example.htm

bob_j · « **Reply #3 on:** December 22, 2002, 01:38:19 am »

Phil,
Thanks so much for answering my question. I would have never found that wizard button. This helps me a lot but still doesn't completely answer my question.

I have a lot of comments about the interface. I'm going to start another thread because I don't think the developers will see this one since they didn't notice my original question.
Thanks again
bj

INTERACT FORUM

Author Topic: How to set SmartList Properties? (Read 736 times)

bob_j

How to set SmartList Properties?

bob_j

Re: How to set SmartList Properties?

Phil Lee

Re: How to set SmartList Properties?

bob_j

Re: How to set SmartList Properties?