OK, Bob. Two parts to this.
Networking:
I am no networking expert, so let me take you through the settings I am doing:
Under selection 13, Network Manager, I select properties for my wired network.
I have static IP checked, with IP 192.168.0.88, Netmask 255.255.255.0 and Gateway 192.168.0.1 (my main router).
I use Comcast so I have DNS domain set at 75.75.75.75 and search domain at
http://www.comcast.comFor DNS Server 1, I have put in the same address that I have in JRemote, to wit 73.185.XXX.XX. I have nothing in under DNS Server 2 or 3.
I checked the Use Encryption box and put in my username and password to match what I use in JRemote.
With this, when I select Use Global DNS Servers, I get an error message that says that Global DNS has not been enabled in general preference. Of course, I don't know where "general preference" is located.
Hi Res:
I created a new DLNA share on the MC22 server called Den Music Player DLNA. Under Audio, Mode is set at Original, Format is set at PCM 24 Bit and Advanced has ...DSP Studio... under it, but I can't make any selection there. Under Video/Advanced, I have the DLNA, DLNAExtra and Enable bitrate Field boxes checked. I selected the Den Music Player zone and associated it with this new DLNA share.
On the RPi3, I already had the sample rate in DSP Studio adjusted to reduce 352.8 to 176.4, 384 to 192 and greater than 384 to 176.4. I rebooted the RPi3.
Same result. SACD ISO pops up on GUI for a moment as opening, then stops. JRemote reports it as an SACD file and has the album art pulled up, but no playback. JCR