Since upgrading to MC 27 around version 33 I have been having issues with my remote acting strange. It will jump two spaces on the guide when scanning up or down and sometimes will jump a whole day. other times I cannot direct access movies or audio unless I go back to the home screen. On the theatre view home screen it will also jump two spaces. I have tried restarting MC and no change. Sometimes if I reboot the PC and then restart MC it will work as normal. The other day I could not get it to work properly so I reloaded version 37 and it worked for two sessions and then went back to acting up. This morning I installed the latest version #43 of MC and it was fine until I reopened MC this afternoon and it is back to acting up again. I have went through all of the taming Windows defender tricks. I enabled logging and I cannot see an issue, There are no entries that mention remote commands. I have all of the latest windows updates but this started happening before I installed the latest ones. I am using a URC MX-850 remote but it also acts up with my HP windows remote. Is there something in the remote commands setup that could cause this to happen?