Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[lisbethfox]

A few months ago I was having serious issues where upon loading most tracks, JRiver would lock up for about 6 seconds. Well after lots of troubleshooting it turns out it was zoneswitch causing the issue. I use zoneswitch rules to go between a 2.0 configuration and a 5.1 configuration automatically. The rules are:
"If channels equal to or greater than 5, use Player" and stop playback in zone 2.0.
"If channels equal to or less than 4 use 2.0" and stop playback in zone Player (Its fine for quad recordings due to how my setup works)
Im pretty sure back in JRiver 18 or 19 I only needed a single rule but an upgrade stopped that.

Any ideas?

[ferday]

not sure i understand 100%, but

zone "player" should have channels equals 2, and stop playback in zone 2 (or all other zones)
zone "2" should have channels is greater than or equal to 2, and stop playback in zone 1 (or all other zones)

did you check your zone rules?  i know mine didn't copy over with the original 21 upgrade, i had to re-do them.  they've now copied over with all my further 21 upgrades but i can't say if they fixed the bug going from 20 to 21

[lisbethfox]

I've recreated the rules multiple times to no avail and I'd rather put all channels up to 4ch in my 2.0 zone as I don't need crossovers for the subs on any of the speakers as they're all identical floor-standers. I just use bass management on 5.1 stuff for convenience.